1. Install and start the machine
1.1 fixed machine;
1.2 connecting the machine to the control cabinet;
1.3 connecting gas;
1.4 connecting the power supply;
1.5 connecting the computer;
1.6 starting the machine;
2. Install the vacuum adsorption system
2.1 connect the suction pipe;
2.2 connect the blowing pipe;
2.3 connect the vacuum pump protection line (connect according to the number);
2.4 connect the power cord (pay attention to safety);
2.5 connect the power supply of the factory (380V, 50Hz);
2.6 connecting the signal line;
2.7 check whether the installation is correct;
3. Install automatic feeding system
3.1 remove all fixing screws;
3.2 place the automatic feeding system parallel to the machine;
3.3 determine the distance between the machine and the feeding system;
3.4 connecting the power supply;
3.5 fixation;
4. Test platform data
4.1 turn on and return to the original point;
4.2 move the cutting head to the lower right side of the machine;
4.3 installation test tools;
4.4 check whether the signal transmission is normal;
4.5 start test platform;
4.6 adjust table;
4.7 save the table data;
4.8 remove the test tool;
5. Install the tools and set the cutting depth
5.1;
5.2;
5.3;
5.4;
5.5;
5.6 setting the cutting depth;
6. Install the machine control software
6.1 installation software;
6.2 setting computer IP;
6.3 reading data from the machine;
6.4 setting optimization options;
7 install nested software
7. Install the digitizer
7.1;
7.2;
7.3;
7.4;
7.5;
7.6;
7.7 connecting digitizer and nested software;
